User Manual

Wireless 802.11a CPE
User Manual
Page 14 of 36
2.2.6. QoS
The QoS configuration page can allow you to configure WMM and Direct Link settings
(1) QoS Configuration
WMM: Enable Wi-Fi Multi-Media.
WMM Power Saving: Enable WMM Power Save.
PS Mode: Select which ACs you want to enable.
Direct Link Setup: Enable DLS (direct Link Setup).
(2) Direct Link Setup
MAC Address: Fill in the blanks of Direct Link with MAC address of STA. Connect with the
same AP that supports DLS features
Timeout Value: Timeout Value represent that it disconnect automatically after some
seconds. The value is integer. The integer must be between 0~65535. It represents that it
always connects if the value is zero.
(3) DLS Status
After configuring DLS successfully, show MAC address of the opposite side and Timeout Value of
setting in “DLS Status”. In “DLS Status” of the opposite side, it shows MAC address of itself and
Timeout Value of setting.