User manual

TV Connection

Activating for Playback

1. Turn on your TV and AV receiver.

2. Press the

STANDBY button on the remote control to activate this device. The

activation takes about 5-7 seconds, and the LED will blink at the same time.

3. After the LED stops blinking and glows steadily bright, this device is ready to use for

playback.

4. After playback, press the

STANDBY button again to return to Standby mode.

Note:

• Always remove USB cable before activating this device.

• When using the remote control, point the remote control towards the front

of this device.

• When this device is off, scheduled recordings will be off.

When turning the HDD into Standby mode, please avoid moving it for 2-3 minutes due

to spin down of the device. Moving the HDD while it is still spinning may damage it. We

are not liable for any data loss or damage caused by inappropriate or careless use.

It is recommended to unplug the unit from the power socket completely when not in

use.