Assembly Instructions

ManualsBrandsArgos Home ManualsClothes rails and canvas wardrobesClothes Rail with Shelves - Silver

Multi-Purpose Tidy Rail

Dimensions

Width - 106cm

Depth - 43.5cm

Height - 166cm

Important - Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Assembly Instructions - Please keep for future reference

875/0352

Issue 1 - 28/05/10

Summary of content (6 pages)

PAGE 1
Multi-Purpose Tidy Rail Assembly Instructions - Please keep for future reference 875/0352 Dimensions Width - 106cm Depth - 43.
PAGE 2
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on page 2. • Assemble on a soft level surface to avoid damaging the unit or your floor. • Remove all fittings from the plastic bags and separate them into their groups. • Parts of the assembly will be easier with 2 people. • Keep children and animals away from the work area, small parts could choke if swallowed.
PAGE 3
Components - Panels If you have damaged or missing components, call the Customer Helpline: 08456 400800 Please check you have all the panels listed below 1 End section x 1 5 Crossbar x 1 (73cm) 2 Upright section x 1 6 Shelf support x 6 (28cm) 3 End section x 1 7 Shelf x 3 4 Base x 1 Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
PAGE 4
Assembly Instructions Step 1 Note: It would be useful to ask someone to help you at this stage. a: a: Insert Threaded end 1 C into End sections cap A 3 . Ensure screw 1 & 2 C correctly of End cap A aligns with hole for D in End section castor A 3 , then screw 1 & 2 D into position Castor A and tighten firmly with F. Spanner A b: Secure Shelf supports to End section 21 using Screws A and E. tighten with Allen key A And then fit Upright support 2 to Shelf supports 26 using Screws A .
PAGE 5
Assembly Instructions Step 2 Finishing the Unit a: Attach Base 4 to End section 1 using Screws A , and then attach to Upright support 2 as shown at the figure. a: A 1 2 4 B A E b: Fix Crossbar 5 to Upright support 2 and End section 3 using Screws A .Then using Screws A attach End section 3 to Base 4 and Crossbar 5 .
PAGE 6
Assembly Instructions Step 3 Finishing the Unit a: Stand product up. Position Shelf 7 over two Shelf support 6 and push down gently until shelf 7 clips into place on both sides. a: 6 7 Assembly is complete.