Assembly Instructions

ManualsBrandsArgos Home ManualsGarden and DIY2 Seater Rattan Effect Balcony Set - Brown

Dimensions

Diameter - 60cm

Height

71cm

Issue 1 - 26/05/10

Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400 800

For further assistance please visit http://www.argos-support.co.uk/

Assembly Instructions -

Please keep for future reference

Steel Wicker Balcony Set - Table

743/6244

Important –

Summary of content (5 pages)

PAGE 1
Steel Wicker Balcony Set - Table Assembly Instructions - Please keep for future reference 743/6244 Dimensions Diameter - 60cm Height - 71cm Important – Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400 800 For further assistance please visit http://www.argos-support.co.
PAGE 2
This product is manufactured from toughened safety glass. In the unlikely event that the glass fails it will break in to a large number of small fragments that may be spread over a wide area. This is a feature of toughened glass, designed to remove the risk of injure from glass breaking into large shards. If the glass is chipped or broken, stop using the product and consult the manufacture or supplier. Check you have all the components and tools listed on page 2.
PAGE 3
Components - Parts Please check you have all the parts listed below 1 Table top x 1 2 Table leg x 4 3 Center connector x 2 Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly.
PAGE 4
Assembly Instructions Step 1 Assembly frame Suggest to complete this product assembly by two person. Place the table top 1 on a non-abrasive surface, such as carpet ,with the underside facing up. Insert the legs 2 into the plastic holders attached on the back of the table top rim 1 . 1 2 1 2 Important: Make sure the plastic support E not detached from leg tube. Step 2 Mount and align the center connector 3 to the middle of the legs 2 , then fasten them by using washers C and screws A .
PAGE 5
Assembly Instructions Step 3 Repeat step 2 to install the center connector 3 . Tighten all the screws A and seal them with caps B . C 3 A B 2 2 3 1 Step 4 Turn the table top 1 to its upright position . Assembly is complete. If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800 For further assistance please visit http://www.argos-support.co.