Assembly Instructions

ManualsBrandsArgos Home ManualsDining room furnitureAmparo Grey Dining Table & 4 Grey Chairs

Amparo Table

Dimensions

Width - 85cm

Length - 85cm

Height - 76cm

Important – Please read these instructions fully before starting assembly

Assembly Instructions - Please keep for future reference

Issue 4 - 7/09/16

If you need help or have damaged or missing parts, call the Customer Helpline:

Argos = 0345 6400800

600/1443

600/6527

600/6352

600/6541

144/7569

259/3807

621/5136

Summary of content (4 pages)

PAGE 1
Amparo Table Assembly Instructions - Please keep for future reference 600/1443 600/6527 600/6352 600/6541 144/7569 259/3807 621/5136 Dimensions Width - 85cm Length - 85cm Height - 76cm Important – Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: Argos = 0345 6400800 Issue 4 - 7/09/16
PAGE 2
Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the components and tools listed on the following pages. • During assembly do not stand or put weight on the product, this could cause damage. • Remove all ﬁttings from the plastic bags and separate them into their groups. • Assemble the item as close to its ﬁnal position (in the same room) as possible.
PAGE 3
Components - Panels If you have damaged or missing components, call the Customer Helpline: Argos = 0345 6400800 Please check you have all the panels listed below 1 Table leg x 4 Table top (85 x 85cm) 2 3 (74 x 19cm) Connecting plate x 4 (10 x 10cm) Components - Fittings Please check you have all the ﬁttings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more ﬁttings may be supplied than are required.
PAGE 4
Assembly Instructions Step 1 A A Assemble table top A Place table top 2 upside down on a clean, ﬂat surface. Fix connecting plate 3 onto the table top using bolts A by using Hex key D A 3 3 3 Note: The direction of the arrows should be pointed outward as shown in the ﬁgure. 3 2 B Step 2 Assemble legs 1 1 Position leg 1 over the connecting board and secure using nuts B by using wrench C . Note: Make sure the direction of the table legs is the same as shown in the ﬁgure during assembling.