Specifications

4
OPENING THE SAFE USING THE OVERRIDE KEY
Use the manual override key to open the safe.
⚫ Remove the plastic key lock cover (dia 1)
⚫ Insert the override key; turn it anti-clockwise, at the same
time turn the locking knob clockwise and pull open the
safe.
BATTERY REPLACEMENT
The digital safe uses 4 AA type batteries (supplied).
⚫ Remove the battery cover on the rear of the door (dia 5).
Push the catch in and pull out the cover.
⚫ Install the 4 AA batteries supplied. Ensure correct polarity.
⚫ Replace the battery cover.
⚫ Keep the safe door open until you have set the PIN code.
The battery life is approximately one year.
Make a note of the battery replacement date; they
should last approximately one year.
However, we recommend checking the batteries
every 6 months just to make sure.
If power is removed from the safe the set PIN code
will be only remained in its memory for
approximately 4 hrs then it will need re-setting.
SECURING YOUR SAFE
ADVICE: WE STRONGLY RECOMMEND THAT YOU SECURE
YOUR SAFE TO A WALL OR FLOOR FOR SECURITY
REASONS.
You may wish to secure your safe to a fixed part of the house
(i.e. stone wall or wooden beam).
This can be achieved by using 2 of the 4 rawlbolts supplied in
the back of the safe or using the 4 rawlbolts supplied in the base
of the safe.
Use the holes in the safe to mark where you need to drill.
Loosely attach the rawlbolts onto the safe with the nuts and
washers provided. Hold the safe over the drilled holes and locate
the rawlbolts into these holes (dia 6). Tighten the nuts from the
inside of the safe to secure firmly.
Note: The rawlbolts are packed inside the safe