Assembly Instructions

Step 15

Step 16

Polystyrene

block

Polystyrene

block

Fit the top

Note: To make it easier

to fit the top and plinths,

place polystyrene blocks

from the packaging

underneath the side

panels to raise the

assembly.

Push the top onto

the assembly.

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

each of the sides and

. .

Polystyrene

block

Polystyrene

block

Polystyrene

block

Profiled

front edge

Fit the back

a: Square up the unit by

making sure that

measurement x to x

equals y to y.

b: Place the back

onto the unit.

Nail around the

outside edges of the

back .

Note: Nails should be

spaced about 150mm

apart.

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y