Assembly Instructions

A B C
D
G
E F
3
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
Please check you have all the fi ttings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fi ttings
may be supplied than are required.
Components - Fittings
H
39mm Locking pin x 19
12mm Screw x 24 50mm Screw x 3015mm Screw x 24
30mm Screw x 10
30mm Dowel x 1112mm Locking nut x 9
15mm Locking nut x 10
I
J K L
Left outside runner x 2Right inside runner x 2Right outside runner x 2
Door hinge x 6
M N O
Nail x 30Left inside runner x 2 Door pad x 3
(This screw is included in
the runners bag)
(This screw is included in
the door hinges bag)