Assembly Instructions

IMPORTANT!
KEEP FOR
FUTURE
REFERENCE
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• Unit weight: 20.4 kgs.
1
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Care and maintenance
Handy Hints
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Warnings
• Regularly check and ensure
that all bolts and fittings are
tightened properly.
• The recommended mattress
size is L1900 x W910 mm.
• This product should only be
used on firm, level ground.
• Make sure the legs remain in
contact with the ground.
• Not suitable for children under
4 years.
• Prohibit your children from
bouncing and jumping on the
bed.
• Do not place this child’s bed
near heat sources, windows
(blind cords, curtain pulls or
other strings or cords) and other
furniture
• Place the bed tight to any wall
or have a gap of 300mm
between the wall and the side of
the bed.
• Do not use this child’s bed if
any part is broken, torn or
missing.
• THIS BED COMPLIES WITH
BS8509:2008+A1:2011
Manufacturer: BL Packaging Co.
Ltd.