Operation Manual

www.argonaudio.com 8
TT- 2
Mains power connection
The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to
ensure compliance with the mains rating in your house.
Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before connecting the power
supply to the mains.
Fitting the lid
Fit the lid carefully over the hinge fasteners and adjust the screws (14) until the lid stays open where you want it to without being
too stiff to open or close.
Switching on and off
Pressing the power switch (1) alternately starts or stops the motor.
Changing replay speed
To play records at 45 r.p.m. first remove the platter (3). Using the accessory tool provided, hook the belt over the larger diameter
part of the motor pulley (2/22). Refit the platter. To revert to 33,33 r.p.m. repeat the proceedings using the smaller step on the
pulley.
Fitting and connecting the cartridge
** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the cartridge to the
headshell using the screws supplied with the cartridge by passing one screw through each slot in the headshell (11). Do not
tighten the nuts yet.
Connect the tonearm wires to the cartridge pins as follows:
white left channel positive (L+)
red right channel pos. (R+)
green right channel return (R -)
blue left channel return (L -)
The full sound quality of the Argon Audio TT2 can only be achieved if the cartridge is correctly adjusted.
If you are not well acquainted with the adjustment of cartridges you are advised to call upon the willing help of your Argon Audio
dealer to accomplish this task for you.