Operation Manual

www.argonaudio.com
Stream 2
56
8.2 Setting up the connection to the Stream2
After you download the UNDOK Wireless Device Remote Control application, you must set up a
connection between the Phone and the Stream2. To do this, follow these steps:
1. On the Stream2, navigate to Menu > Main menu > System settings > Network > Keep
network connected, and select YES.
The network connection now stays on when the device is in standby mode. This setting is
retained in the device’s memory after it is switched off and on again.
2. Set the Phone to use the same network access point as the Stream2 as follows:
a. Select Settings > Wi-fi.
b. Choose the network of the Stream2. from the list.
c. If asked for a PIN code the default PIN code is 1234
Notice: the feature: Set up audio system” in the UNDOK app only applies for Devices without display
(Stream2 has a display so setup is done directly on the Stream2)
9. Inactive standby
Out of the box, the Stream2 come with an automatic standby function. If the product is not operated for two
hours it will automatically go into standby. This applies also if the product is playing music.
This “feature” is a result of an EU law taking effect as of January 1
st
2014.
To deactivate or change this “feature”, do the following:
- Choose “Menu” , Go to “System settings”, Scroll down to “inactive standby” and press select
- Choose your preferred setting and press select