Operation Manual

www.argonaudio.com
Stream 2
18
3.1 Setup wizard
When Stream2 is started for the first
time, it runs through a setup wizard to
configure settings for date/time and
network. Once this has finished, the
system is ready to use in most modes.
Note: To change these settings later,
select Menu > System settings >.
To run the setup wizard again, select
Menu > System settings > Setup
wizard.
Select Yes to start the setup wizard.
If you choose No, the next screen asks
if you would like to run the wizard next
time Stream2 is started. The system
then starts without configuring
time/date and network settings and
enters the Main Menu.
Note: If power is removed while the
wizard is in progress, the wizard will
run again next time Stream2 is started.