Operation Manual

www.argonaudio.com 12
O c t a v e 3 A
Specifications Argon Octave 3A
Tweeters: 0,75 inch Silk Dome with Neo magnet
Woofers: 2,5 inch paper cone
Nominal Impedance: 8 Ohm
Sensitivity: 2,83V (/1W/1m) 84 dB
Amplifier Type: Class D with ext. power adpt (20V DC @ 3A
Power Output: 20 Watts RMS per channel
Input Sensitivity: 350 mV
Total Harmonic Distortion: < 0.3%
Crossover System: 2-way
Crossover Frequency: 3 kHz
Frequency Response: 70 Hz - 20 kHz
Bluetooth: 3.0
Outputs: 1 x Subwoofer
USB Audio 2,0
Speaker Terminals: Left and Right Binding Posts
Input Voltage / Frequency: AC 100V-240V 50/60 Hz
Standby Power Consumption: < 0.5 W
Basic Troubleshooting
If the LED does not light up, check...
that the AC power cord is firmly plugged into the rear panel
and wall outlet.
to make sure the speaker rear panel power switch is ON.
that the speaker is getting power from the wall outlet.
that the rear panel match to the operating voltage.
the fuse in the AC IN on the rear panel. If the fuse needs to
be replaced it is extremely important to replace only with
same fuse type and value.
If no sound output, check...
that the speaker is turned on (blue LED illuminated)
to make sure the right speaker is connected correctly to the
left.
that the volume on the speaker back panel is not all the
way down.
the volume level on the iPod or other audio source it not at
0 level..
that there is music playing on your iPod or other audio
source player.
If bass output is low, check...
speaker wire polarity (verify that wires are going to same
terminals on both speakers)
that the speaker placement is not too close to a wall or
other obstruction.
that the bass ports on the rear panels are not blocked by a
rodent or jelly sandwich.
If no output from right speaker, check...
that the speaker wire is properly connected from the left to
right.
Check by removing the speaker wire from both terminals on
each speaker and reconnecting.