Operation Manual

www.argonaudio.com
iNet2+
64
11.2 Setting up the connection to the iNet2+
After you download the UNDOK Wireless Device Remote Control application, you must set up a
connection between the Phone and the iNet2+. To do this, follow these steps:
1. On the iNet2+, navigate to Menu > Main menu > System settings > Network > Keep
network connected, and select YES.
The network connection now stays on when the device is in standby mode. This setting is
retained in the device’s memory after it is switched off and on again.
2. Set the Phone to use the same network access point as the iNet2+ as follows:
a. Select Settings > Wi-fi.
b. Choose the network of the iNet2+. from the list.
c. If asked for a PIN code the default PIN code is 1234
Notice: the feature: Set up audio system” in the UNDOK app only applies for Devices without display (iNet2+
has a display so setup is done directly on the iNet2+)
12. Inactive standby
Out of the box, the iNet2+ come with an automatic standby function. If the product is not operated for two
hours it will automatically go into standby. This applies also if the product is playing music.
This “feature” is a result of an EU law taking effect as of January 1
st
2014.
To deactivate or change this “feature”, do the following:
- Choose “Menu”
- Go to “System settings”
- Scroll down to “inactive standby” and press select
- Choose your preferred setting and press select