Specifications

www.argonaudio.com
iNet6+
55
11.2 Setting up the connection to the Argon iNet6+
After you download the Wireless Device Remote Control application, you must set up a connection
between the iPhone/iPod and the Argon iNet6+. To do this, follow these steps:
1. On the Argon iNet6+, navigate to Menu > Main menu > System settings > Network >
Keep network connected, and select YES.
The network connection now stays on when the device is in standby mode. This setting is
retained in the device’s memory after it is switched off and on again.
2. Set the iPhone/iPod to use the same network access point as the Argon iNet6+, as follows:
a. Select Settings > Wi-fi.
b. Choose the network of the Argon iNet6+ from the list.
c. PIN code is default 1234