Instruction manual

www.argonaudio.com

iNet2+

1. Place iNet2+ on a suitable shelf or table

2. Connect the power adaptor between iNet2+ and the mains supply.

3. To receive broadcast radio (DAB and FM), extend the telescopic antenna.

The setup wizard starts.

3.1 Setup wizard

When iNet2+ is started for the first

time, it runs through a setup wizard to

configure settings for date/time and

network. Once this has finished, the

system is ready to use in most modes.

Note: To change these settings later,

select Menu > System settings >.

To run the setup wizard again, select

Menu > System settings > Setup