Owner`s manual

www.argonaudio.com 9
DA2 V2
Notice: If DA2V2 is connected with a Argon iNet6+ they have to be connected only by Optical digital out/in.
If iNet6+ is connected to DA2V2 via analogue RCA the volume function on the remote will not work properly
Power Management (Auto Stand-by)
According to the EC regulations implemented January 1
st
.
2013 Argon Audio DA2V2 will automatically go into auto
standby if it is without a music signal for 20 minutes.
This rule is applied by the EC in order to save power
consumption.
Basic Troubleshooting
If the LED does not light up, check...
that the AC power cord is firmly plugged into the rear panel
and wall outlet.
to make sure the amplifier rear panel power switch is ON.
that the amplifier is getting power from the wall outlet.
that the rear panel voltage match the operating voltage.
the fuse in the AC IN on the rear panel. If the fuse needs to
be replaced it is extremely important to replace only with
same fuse type and value.
If no sound output, check...
that the amplifier is turned on (blue LED illuminated)
to make sure the speakers are connected correctly
that the volume on the front panel is not all the way down.
the volume level on the iPod or other audio source.
If bass output is low, check...
speaker wire polarity (verify that wires are going to same
terminals on both speakers + to + and – to -)
Using Optical cable… ensure that you have removed the
small plastic covers from the Optical cable connections
Specifications:
Type: Full class D, digital amplifier
Inputs: Digital USB2.0, 2 x Optical digital,
Analogue L/R RCA stereo input
Output: SUB-OUT, 1 set speaker output
Main voltage: 220-240V, 50/60Hz
Distortion: @4ohm 20-20Khz 0,3% @8ohm 20-20Khz 0,2%
Input sensitivity: 500mV (RCA) analogue
Frequency Response: (-1db @1Khz): 20Hz-20Khz
Output Power: 2X50W (RMS @4ohm)
Resolution: USB2.0 16bit/48Khz, Optical max.
16 bit/96Khz
Optical processing: Burr Brown 2704 processed via Sp/diff
and then D/A converted by AKM4388A
Notice: optical is not supported via Bluetooth to an Argon
BT2. Instead, use analogue input on DA2V2, if you intend to
connect an Argon Audio BT2 Bluetooth adaptor).