Installation instructions

INSTRUCTIONS FOR USE
Turn off all the controls of the fan heater, and then plug the power plug directly into a standard
grounded AC outlet. Be sure plug fits tightly into outlet.
The fan heater includes an overheat protection system that shuts off the appliance when parts
of it are getting too hot.
To completely shut the fan heater off, turn all the controls to OFF, and remove plug from the
socket-outlet normally.
a. Press the button ON/OFF to activate the fan-motor and check if it operates normally.
The power pilot light will be illuminated. And the LED display will show the current
ambient temperature.
b. Press the button HEAT to choose the desired power. Press once or more the power
will cycle as below:
1000W 2000W
The pilot light corresponding to the selected power will be illuminated.
c. If you want to enlarge heating area in your room, press the button SWING, the swing
bar will swing and the fan heater will heat your room in large scope, the swing pilot
light will be illuminated. To stop swing, just press the button SWING again, the swing
pilot light will go out.
d. This heater has a sensitive temperature detector, which automatically monitors the
current ambient temperature and switches the unit on to maintain your room
temperature once you start the heater heat your room.
The temperature default is 30
, if you want to select a desired room temperature, just
press the TEMP. button to set a desired temperature level, the range is between 15-36
. If the selected temperature is higher than the actual room temperature, the
appliance will start automatically and rapidly heat the room until it reaches the selected
temperature. The unit will automatically maintain the temperature at a constant level.
e. The function of item a-d can be carried out with your remote control by pressing the
corresponding function button. Other than the above, you can use the REMOTE
CONTROL to select a desired timing level. Just press the button TIMER once or more,
the time will show on the LED display and cycle as below: the range is between 1-8
hours. The TIMER pilot light will be illuminated.
1 - 2 7 - 8
OFF
cancel TIMER