Technical data

5
CONTROL PANEL AND REMOTE CONTROL
A. ON/OFF
B. ANION (IONIZATION)
C. PHOTOCATALYSIS
D. STERILIZATION
E. REVIVAL
F. WIND
G. TIMER
H. UV LAMPS
I. LIGHT FOR FILTER SUBSTITUTION –
(MAINTENANCE)
J. RESET
The air purifier can be used both with the control panel and with the remote control.
Switch on/off: Press button ON/OFF(A), the indicator will light. The appliance begins to
work in PHOTOCATALYTIC mode purification at the intermediate speed and two UV
lamps will be on.
Setting the speed: Set wind speed (HIGH MEDIUM LOW) by pressing the button WIND.
Switch on time selection: Press the button TIMER(G) in order to set the switch on time
(1hr, 2hr, 4hr, 8hr). When the indicator is off, the timer is not selected.
Ionization function: By pressing the button ANION (B), some negative ions will be generated.
Photocatalysis and sterilization function: by pressing the button PHOTOCATALYSIS and
STERILIZATION the process of photocatalysis and ionization will take place at the same time.
If the function of sterilization is selected with the timer, the appliance will set automatically to
PHOTOCATALYSIS mode.
Revival: In the mode revival, only two UV lamps will be on without letting the motor work.
The revival function is needed in order to clean the photocatalytic filter by means of UV lamp
without air circulation.
UV lamps status:
Three indicator will light in the top left angle of the control panel and show the status of the
UV lamps. When the appliance work in photocatalysis mode, two indicators will light.