Specifications

The function of continuous drainage can be started in following steps
when there is a good condition of drainage near by the unit.
CONTINUOUS DRAINGE
Drain hose
Back of the unit
Drain cover
-5-
1. To save having to periodically empty the
water tank, this unit can be configured
for continuous drainage. You can use the
supplied drain hose to connect to the
continuous drainage connector.
2. Unscrew and remove the drain cover at
the rear of the unit.
3. Remove the soft rubber stopper. Put it
into the water tank for safe keeping.
4. Insert the drain hose through the hole of
the drain cover.
5. Connect the drain hose to the drain port.
6. Tighten the drain cover in clockwise
direction onto the rear of the unit.
7. Place the bucket on its original location.
Drain cover
Drain cover
Soft rubber
stopper
Drain cover
Drain hose
Drain cover
Drain hose
Drain hose
Bucket
INSTALLING DRAINAGE PVC HOSE
When using the function of continuous drainage, the PVC hose must be placed horizontally
below the drainage hole. Must avoid uneven ground and folding the hose.