Operating instructions

V 01/12

3. HEATING MODE

 Press to select Heating until the relevant icon appears.

 By default, the temperature is set to 25ºC.

 The temperature can be adjusted between 15° and 25°C.

 In this way, each time the Power button is pressed, the unit switches off, the appliance saves the temperature set

and when switched back on again, it will retain this setting.

 In this way, fan speed can be adjusted, the Timer and Sleep function can be set.

TO USE THE AIR-CONDITIONER IN HEATING MODE, ROTATE THE PRODUCT 180º AROUND ITSELF AND

CONNECT THE CONNECTOR AND THE FLEXIBLE HOSE AS USUAL; THEN SELECT THE HEATING FUNCTION

ON THE REMOTE CONTROL OR, IF YOU DO NOT HAVE A REMOTE CONTROL, ON THE CONTROL PANEL.

4. FAN MODE

 Press to select Fan until the relevant icon appears.

 When the unit operates in this mode, the display will show FF and the icon lights up.

 This enables the adjustment of fan speed.

 The temperature cannot be regulated.

HOW TO ELIMINATE CONDENSATE

This equipment automatically vaporises the condensation in Cooling and Heating mode.

Ensure that when the unit operates as Cooling or Heating, the rubber cap that closes the discharge hole at the back is

correctly positioned.

When the air-conditioner operates on Cooling and Heating, there is no need to arrange for continuous drainage of

condensate; only in specific weather conditions where air humidity levels are very high may water deposit within the unit.

When the internal tank is full, the blue LED flashes to warn that it is full and blocks the appliance function.

To empty the internal tank, release the two upper sides of the left grille (front view

of the air-conditioner) and remove the lower part too, pulling it gently towards you,

removing the panel completely.

Release the tube from above and rotate downwards; then connect to a plastic

tube or tank to drain the condensation, placing the other end above a normal

drain: press the PUMP BUTTON on the control panel near this tube to activate

the condensation drainage pump.

This will enable the easy elimination of the condensation from the unit, collecting

it into another container for potential re-use.

Replace the tube in its original position, close the panel and start using the air-

conditioner again.

ATTENTION!

When using the air-conditioner in Dehumidification mode, we recommend always ensuring continuous drainage, in

order to guarantee maximum dehumidification efficiency.