Operating instructions

4
V 06/10
HOW TO USE THE FAN HEATER
Put the fan heater vertically on a flat and stable surface.
Connect the power cord to a suitable electric socket (230V).
Starting from the “❄” position, turn the thermostat knob clockwise in maximum position.
Turn the switch knob, the pilot light switch on: select one of the possible positions:
u = cool air (cool fan)
I = hot air (1000 W ) (low temperature)
II = very hot air (2000 W )(high temperature)
The thermostat maintains the desired room temperature switching on and off automatically the appliance. The more the
knob is turned clockwise, the higher is the maintained temperature. Maximum thermostat setting corresponds at about
35°C; “❄” position corresponds to approximately 5°C.
In a room where the temperature is too high (more than 35°C), it is normal that the thermostat will not switch on the heater.
In a room where the temperature is too low (around 5°C or even less) it is also normal that the thermostat will keep the
appliance working until the temperature gets higher.
Leave the appliance working until the comfortable temperature is reached; - turn the knob anti clockwise until you hear a
"click" and the appliance stops; - turn clockwise again the knob (just a little): in this position the thermostat will maintain
the comfortable temperature you have selected.
OVERHEATING SAFETY DEVICE
In case of overheating the safety cut out protecting the heating element will automatically switch off the appliance.
In this case the appliance stops working and the pilot light will remain switched on even if the appliance is not working. If
this happens:
• switch off the fan heater;
• remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille);
• leave the heater cool down for 15/20 minutes;
• switch on again the fan heater.
MAINTENANCE
WARNING:
ALWAYS UNPLUG THE CORD AND LEAVE THE APPLIANCE COOL DOWN BEFORE
MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER.
CLEANING
Use a soft dry cloth to clean the outer surface
Do not use water, oils, chemicals that can damage the surface.
Use a vacuum cleaner to remove dust from the air intake and outlet.
STORAGE
Make the heater cool down, dry and pack well, and then put the product in a dry and ventilated place for stocking.
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN DIRECTIVE
2002/96/EC
At the end of its working life this equipment must not be disposed of as an household waste. It must be taken to special local
community waste collection centres or to a dealer providing this service. Disposing of electrical and electronic equipment
separately avoids possible negative effects on the environment and human health deriving from an inappropriate disposal and
enables its components to be recovered and recycled to obtain significant savings in energy and resources. In order to
underline the duty to dispose of this equipment separately, the product is marked with a crossed-out dustbin.
www.argoclima.com
MADE IN CHINA