Instruction Manual

18
V 02/21
Press the Heating button to select the desired heating power, LED indicator will be on accordingly the selected power
high or low
It’s possible in any moment to turn off the heater pushing the button Stand-by, the heating elements will stop and fan will
operate for approx. 30 seconds, allowing the appliance to cool down before switching off.
TIMER BUTTON
During operation, push the button Timer to select the set the automatic switch-off time of the heater (from 1 to 7 hours): the
correspondant LEDs will light up on the control panel accordingly the selection made.
DIGITAL THERMOSTAT CONTROL BUTTON
During operation, press digital Thermostat control button to select the desired temperature (from 15°C to 35°C with 5 step
levels at 5°C intervals): when the room temperature rises the set temperature, the appliance stop heating while continuing
ventilation, until the room temperature will drop a few degrees. At that point the appliance will automatically reactivate.
In heating mode the Thermostat set temperature must be higher than room temperature, otherwise heater will not work.
MAINTENANCE AND STORAGE
ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.
IMPORTANT: DO NOT SUBMERGE THE CERAMIC FAN HEATER IN WATER
Cleaning the outside surface of the appliance
Turn the switch off and unplug before carrying out any maintenance work or moving the appliance.
Use a damp cloth to remove any dust from the fan heater.
If the fan heater is excessively dirty, use a soft cloth moistened with water, or use a vaacum cleaner to remove the dust
from the air inlet/outlet grilles, or with a soft brush. Let the fan heater dry completely before use.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils,
chemical substances or other items to clean that may damage the surface.
STORAGE
If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a
cool and dry place.