Instruction Manual

17
V 02/21
HOW TO USE THE HEATER
Put the heater vertically on a flat and stable surface.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
Turn on the heater pushing ON/OFF main switch, which is located on the back side of appliance. LED indicators and
control panel will light up.
Press the button Stand-by to turn on the heater.
This appliance is protected with a safety switch that turns off the appliance automatically when the heater falls over, or in
case of excessive inclination, to prevent accidents. The heater will back in stand-by mode, press the buttons on control
panel to reset the appliance.
In the event of abnormal heating, a safety device automatically shuts down the appliance. After a short cooling down
phase, the appliance is ready to be used again. If you notice the same defect as above mentioned, remove the plug from
the socket and contact and authorized service center.
During the use, do not touch or cover the air outlet, this could cause an overheating and activate the safety device.
CONTROL PANEL AND ACTIVABLE FUNCTIONS
After connecting the power cord, the heater will enter in Stand-by mode, and the indicator will light up on the control
panel.
To turn on the appliance touch the button and the indicator of ventilation will light up: now the appliance will
emit cold air. To release hot air touch Heating button to select the desired temperature.
To turn off the heater touch the button the appliance will enter in Stand-by continuing to ventilate, but gradually
decreasing the heat emitted, while the indicator of ventilation will blink for 30 seconds, then ventilation will stop and
the heater will enter in Stand-by mode.
To turn off the heater push the main ON/OFF switch located on the back side of appliance.
HEATING BUTTON