EN CERAMIC TABLE FAN HEATER WILMA OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference. This product is only suitable for well insulated spaces or occasional use.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the fan heater data plate (220-240V~50Hz).
WARNING: do not use the fan heater with a controller or any other external device that activates the appliance automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned. Do not restrict the air inlet and outlet grilles. The appliance heats up slightly when in use. In order to avoid burns, do not let bare skin touch hot surfaces. Ensure that all objects are at least 1 meter from the front and sides of the appliance.
The most common cause of overheating is the build-up of dust in the appliance. Remove dust deposits by unplugging the appliance and cleaning the air outlets and grilles with the aid of a vacuum cleaner. Do not use abrasive detergents for cleaning this appliance. Clean the appliance with the aid of a damp (not wet) cloth. Always remove the plug from the mains socket before cleaning. To disconnect the fan heater, push the switch to OFF and remove the plug from the socket. Pull on the plug only.
Do not run the cord under carpets. Do not cover the cord with blankets, carpets or similar materials. Place the cord far away from busy areas or where it cannot be accidentally pulled-out. Do not operate the fan heater in close proximity to bathtubs, showers, washbasins or pools. The heating appliance must not be positioned immediately below a power outlet. Do not operate the appliance outdoors. Upon initial start-up, the fan heater may emit a slight, harmless smell.
DESCRIPTION OF PARTS Control panel and LED indicators Handle Metal grille Decoration ring Feet Main ON/OFF switch Inlet air grille V 02/21 16
HOW TO USE THE HEATER Put the heater vertically on a flat and stable surface. Connect the power cord to a suitable electric socket (220-240V~/50Hz). Turn on the heater pushing ON/OFF main switch, which is located on the back side of appliance. LED indicators and control panel will light up. Press the button Stand-by to turn on the heater.
Press the Heating button to select the desired heating power, LED indicator will be on accordingly the selected power high or low It’s possible in any moment to turn off the heater pushing the button Stand-by, the heating elements will stop and fan will operate for approx. 30 seconds, allowing the appliance to cool down before switching off.
INFORMATION REQUIREMENTS FOR ELECTRIC LOCAL SPACE HEATERS Annex II - Ecodesign requirements - Requirements for product information COMMISSION REGULATION (EU) 2015/1188 of 28 April 2015 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for local space heaters Model identifier(s): WILMA Item Symbol Value unit Heat output Item unit Type of heat input, for electric storage local space heaters only (select one) Nominal heat output Pnom
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN DIRECTIVE 2012/19/EU At the end of its working life this equipment must not be disposed of as an household waste. It must be taken to special local community waste collection centres or to a dealer providing this service.
