Operation Manual

23
V 09/16
2. Placing the bracket against the wall, use a pencil to mark the 4 points on the wall where you need to make the
holes for the rawlplugs. Adhere to the above minimum distances from the walls.
3. Using an electric drill (not supplied) at low speed, drill 4 holes of 5/16 inch diameter to a depth of at least 1.5 inches,
on the marked spots.
4. Insert 4 large plugs (2) into the holes with a hammer until they are flush with the wall.
5. Fasten the mounting bracket (3) to the wall using four M5 x 50 mm screws (3), as shown in the figures below.
6. Fit the firebox onto the hooks at the bottom of the mounting bracket, and push the top of the firebox onto the
mounting bracket as shown.
7. Hold the fireplace in position and secure it to the mounting bracket by replacing the two small screws that were
removed in step 2, as shown in the figures below.