Operation Manual

29
V 09/16
Use Lithium/Manganese button cells, model no. CR2025 -3 V, compliant with Battery Directive no. 2006/66/EC (supplied
with the remote control).
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below) Open the battery
cover on the back of the remote control (press and pull the rear cover). Place the battery inside the cover, making sure
the polarity is correct. Slot the cover back into position on the remote control.
INFORMATION FOR THE CORRECT DISPOSAL OF BATTERIES IN ACCORDANCE WITH EUROPEAN DIRECTIVE
2006/66/EC
Replace batteries when they are depleted. At the end of their life, batteries must be disposed of separately from unsorted
waste. They must be taken to designated recycling centres or returned to a retailer providing this service. Separate
disposal of batteries prevents potential negative effects on the environment and human health due to inadequate
disposal, and also allows for recovering and recycling their constituent materials, resulting in significant savings in terms
of energy and resources. The separate disposal obligation is underlined by the crossed-out dustbin symbol appearing on
the battery. Illegal disposal of the product by the user shall result in administrative sanctions being applied as per current
regulations.
OVERHEATING SAFETY DEVICE
In case of overheating, the safety system of the appliance automatically disables the heating elements and the motor, thus
shutting down the operation of the fireplace.
In this case:
 remove the cause of the overheating (e.g. obstacles on the air intake/outlet grilles, dust deposits in the appliance, etc.);
 allow the unit to cool for 15/20 minutes;
 turn on the fireplace again and ensure it operates correctly.
If the procedure was followed properly and the unit still fails to operate, check the fuse in the wall socket. If this is not the
cause, contact a service centre.
REMOTE CONTROL
Flame effect (7
variations)
selection button
TIMER button
Side LED
selection/off button
Thermostat on/off
button
Temperature
selection button
"POWER" button