Operation Manual

V 09/16

4. Position the firebox on the upper support bracket so that the hooks of the support are inserted correctly into the slots

at the bottom of the firebox and the rear mounting holes overlap.

5. Insert 3 M4 x 8 mm screws (1) through the mounting holes and tighten securely with a Phillips screwdriver, as shown

in the figure below.

Firebox

Table top support

Firebox

Table top support

6. Lift the glass panel into place, and then move it and secure it to the firebox, ensuring that the 2 hooks on the rear of

the upper part of the panel engage securely with the slots on the top of the firebox as shown (1).

NOTE: We recommend that this operation be performed by two people in order to avoid damage to the glass panel

or the firebox.

7. Grasp and fix the bottom part of the glass panel to the firebox (2), using two M4 x 8 mm screws (3) on both sides, as

shown in the figures below.

Firebox

Upper firebox support

Side view

Rear view

Wall