EN DESK AND STAND FAN OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference.
. GENERAL SAFETY INFORMATION • Use this fan only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. • Ensure that the mains power complies with the voltage specified on the fan ’s data plate (220-240V~/50Hz). • This product is not a toy. Children should be adequately supervised to ensure that they do not play with the appliance.
DESK FAN - DESCRIPTION OF PARTS 1. Front grille 2. Nut 3.Blade 4. Ring 5. Body 6. Control panel 7. Buttons 8. Base 9. Remote control STAND FAN - DESCRIPTION OF PARTS 1. Front grille 2. Nut 3. Blade 4. Ring 5. Body 6. Control panel 7. Buttons 8. Inner rod 9. Height adjustment ring 10.Base 11.Handle 12. Motor housing 13.Screw 14.Cable 15.Real grille 16.
STAND AND TABLE FAN - ASSEMBLY INSTRUCTIONS Open the box and remove the parts of the appliance. Motor shaft. Tighten the nut on the motor shaft (caution - counterclockwise direction). Insert the rear grill on the motor shaft in the proper position (hanlde upward). Screw the nut in order to fasten the rear grill firmly. Set the blade on the motor shaft.
STAND FAN - ASSEMBLY INSTRUCTIONS Open the box and remove the parts of the appliance. CONNECT THE ROD TO THE BASE USING THE SUPPLIED LOCKING LEVER AND FOLLOW THESE INSTRUCTIONS: 1. The fan is supplied with the locking lever included into the outer rod. 2. Loose the locking lever. 4 Insert the base below the outer rod. 5. Tighten the locking lever. 3. Remove the locking lever. 6. The base is inserted. 7. Unscrew the ring for adjusting the height and pull out the inner rod. 8.
Press ON/OFF on the control panel or remote control. A sound will indicate that the appliance is on, with low fan speed. This fan can be used both as a fan, with 3 modes (NATURE, SLEEP and NORMAL,, when no mode has been selected) and 3 fan speed options (low, medium and high). In each of the 3 modes, by pressing the SPEED button you can change the fan speed (low - L, medium - M, High - H) which is fixed if the SLEEP and NATURE modes and are not selected, but can be changed in NATURE and SLEEP modes.
REMOTE CONTROL TIMER button MODE SELECTION button (MODE) Allows you to adjust 3 modes: SLEEP, NATURE or NORMAL (no mode selcted). SPEED button SWING button (OSC) ON/OFF button HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below) Open the battery cover on the back of the remote control (press and pull the cover). Place the batteries inside the cover, making sure the polarity is correct. Slot the cover back into position on the remote control. Use no.
If the fan is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower than 50°C. Let the fan dry completely before use. Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical substances or other items to clean that may damage the surface. Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
