Technical data

18 Address
Changing the Address of the Air Conditioner
In case of more than one air conditioner operating in the same room, it may be necessary to assign an
address to each unit in order to avoid operation conflicts. Address is set acting on jumpers located
on the unit PCB and on dip-switches of the remote controller. The PCB settings must match the
corresponding ones on the wireless remote controller
How to change address of the air conditioner
Dip switch is located on the battery compartment.
1) Pull out the door and remove the batteries.
2) Set the switch SW1, SW2 and jumpers on PCB according to the table below
(do not act on SW3 and SW4)
3) Insert the batteries and pull on the door
As default switches SW1 and SW2 are in off status (remote controller factory state).
UNIT ADDESS
JP 1 JP2 JP3 1 2 3 4
1 open closed closed off off on on
2 open open closed on off on on
3 open closed open off on on on
4 open open open on on on on
As default switches SW1 and SW2 are in off status (PCB factory state).
DIP SWITCH (REMOCON)JUMPERS (PCB)
Pagina 17