Operator`s manual

45
SECTION 10
ACCESSORY INFORMATION
WARNING
CAUTION
WARNING
To fold the convertible top for storage, unzip the side and
rear doors and the side panels, lay them aside and unsnap
the domes along the front of the roof panel from the
windshield frame. Fold the aluminum top frames together
and roll the overhead panel around the frames loosely. Then,
roll the window panels around the top material so the boot
will cover the complete assembly for protection.
The convertible top assembly is not designed to with-
stand the turbulence created while transporting the
vehicle with the top assembled in the ‘up’ position. Fold
the top down and secure it properly to the vehicle body
or remove it from the vehicle for high speed transpor-
tation.
Hearing protection is strongly advised when operating
the vehicle equipped with any convertible top assem-
bly.
The following decal should be attached to the inside of the
windshield:
If this decal is not attached to the windshield, contact your
Argo retailer for a free-of-charge replacement. The part
number is 126-84.
10.17 ALTERNATOR KITS (Part No. 650-60 & 850-60
for the Vanguard, Vanguard2, Bigfoot & Response/Part
No. 850-40 for the Conquest)
The externally mounted, belt driven, 40 amp alternator is
recommended when electrical accessories such as a winch
are added to the vehicle.
There is a red charge indicator light installed in the dash, to
the right of the ignition switch. If the red light comes on, the
alternator is not sending a charge to the battery. This may
simply be a result of low engine idle speed. If the light stays
on at vehicle operating speeds, have your Argo retailer serv-
ice the system soon.
10.17.1 Alternator Kit for Conquest (Part No. 850-40)
Check the V-belt tension frequently to be sure belt deflection
is no more than 1/8" or 3 mm with approximately 6 lbs. or 3
kgs of force applied to the belt, halfway between the pulleys.
Adjust the belt tension as necessary. Failure to do so will
reduce the charge rate and lead to battery failure.
10.18 SNOW PLOW KIT (Part No. 657-00)
The snow plow assembly attaches to the front of the Argo at
two mounting brackets that bolt to the front axle bearing
extension housings. The plow blade is raised and lowered
by operating the power winch in and out.
DO NOT STAND BETWEEN THE PLOW BLADE AND
THE FRONT OF THE ARGO. Injury could result if
the blade is raised.
The vehicle operator must observe caution when oper-
ating the vehicle and snow plow in the presence of oth-
ers. Injury could result if a bystander is struck when
the vehicle swings to turn or the blade is lowered onto
someone’s foot. Always be aware of the area being
plowed. Although there is a blade trip mechanism fea-
ture of the blade, damage or operator injury could re-
sult from hitting rocks, stakes or curbs hidden under
the snow being plowed.
10.19 AMPHIBIOUS TRAILER (Part No. 695-75)
The Argo four wheel amphibious trailer is designed as an
additional cargo carrier for any Argo model. It is not in-
tended for the transportation of people. Trailer load capacity
is 600 lbs or 270 kgs at a recommended tire pressure of 4 psi.
10.19.1 Operating Precautions
Keep cargo low and centered in the trailer, especially if used
in the water. Secure the load in place to keep it from shifting
when traveling in uneven terrain. Avoid sudden stops when
towing the trailer downhill to prevent the trailer from collid-
ing with or passing the Argo.