EN AIR PURIFIER OPERATING INSTRUCTIONS Read the instructions carefully before operating or servicing the air purifier. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Store these instructions in a safe place for future reference.
GENERAL OPERATING AND SAFETY INSTRUCTIONS This appliance is a highly efficient air purifier designed for domestic use only! Use this air purifier only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or malfunctions. The unit must be placed in a vertical position at all times. Ensure that the available power source conforms to the required voltage and frequency (220 - 240V/50Hz).
Do not place heavy objects on the appliance. Do not use the appliance on unstable or sloping surfaces. The air purifier must be placed at least 50 cm from the wall or from other obstacles, to ensure proper heat dissipation. Close all open windows to maximise air purification efficiency. Do not insert objects or sharp instruments into the air outlet grille. Do not cover the air intake and outlet grilles in any way.
DESCRIPTION OF PARTS FRONT VIEW (13) (12) (11) (14) (10) (3) 1) CONTROL PANEL AND DISPLAY 2) FRONT PANEL 3) ON/OFF BUTTON 4) PRE-FILTER 5) FILTER FRAME 6) AIR INTAKE 7) COTTON PRE-FILTER 8) HIMOP FILTER 9) HEPA FILTER (9) (1) (8) (7) (6) (2) (4) (5) 10) FILTER FRAME 11) ACTIVATED CARBON FILTER 12) FILTER SUPPORT REAR VIEW 13) IONISER 14) REAR SECTION (18) (15) (16) 15) HANDLE 16) AIR DISCHARGE (17) (19) 17) IONISER/PLASMA 18) REMOTE CONTROL SLOT 19) PLUG PRE-FILTER.
OPERATING INSTRUCTIONS APPLIANCE START-UP Place the product on a flat and stable heatresistant surface, at least 1 metre away from flammable or heat-sensitive materials and 50 cm away from walls or other objects. Connect the power cord to a suitable electric socket (220-240V/50Hz). Remove the plastic seal from the HIMOP + HEPA filters prior to using the appliance, and place it inside the air purifier as shown in the adjacent sequence.
CONTROL PANEL AND REMOTE CONTROL LOCK LED DUST LED FAN SPEED LED DUST SENSOR RUNNING MODE LED MODE BUTTON ON/OFF BUTTON ODOUR LED HIMOP/HEPA FILTER ODOUR TIMER CHANGE LED SENSOR ON/OFF BUTTON: press the ON/OFF button to turn the appliance on and off. The MODE button on the air purifier allows for manually setting the following modes: AUTO-TURBO-SLEEP-ANION-ODOR. This button cannot be used to set the ventilation mode. The speed is adjusted automatically.
CLEANING AND MAINTENANCE MAINTENANCE OF THE AIR PURIFIER’S OUTER SURFACE Warning Always pull the air purifier's plug out of the power socket before cleaning it, to prevent electric shocks or malfunctions. Warning Do not wet or immerse the air purifier in water, as this may cause electric shocks. Use a damp and soft cloth to clean the outer surface of the air purifier. Do not use solvents, petrol, xylene, talcum powder or brushes to clean the unit: these may damage the surface or colour of the casing.
For improved efficiency, the pre-filter should be cleaned regularly. First use a vacuum cleaner then water to wash the pre-filter. Use neutral detergent if the pre-filter is very dirty. Put the filter back into place after cleaning it and leaving it to dry. Press the MODE button for 5 seconds: the CLEAN indicator light will switch off. 3. Cleaning the sensors. Use a vacuum cleaner to remove dust from the access openings of the ODOUR SENSOR and DUST SENSOR. 4. Cleaning the cotton, HIMOP and HEPA filters.
