EN PORTABLE AIR CONDITIONER (LOCAL) OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance work. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Store these instructions in a safe place for future reference.
GENERAL OPERATING AND SAFETY INSTRUCTIONS This appliance is a portable air conditioner designed for domestic use. Only use this air conditioner as described in this manual. Ensure that the required voltage and frequency (220-240 V/50 Hz) match the available power source.
This air conditioner can be used by children of 8 years or older and by persons with reduced physical, sensory and mental abilities, or lacking the necessary experience and knowledge, provided they are supervised or instructed on its use by a person responsible for their safety, so that they are fully aware of the attendant risks. Before moving or cleaning the appliance, ensure that it is unplugged from the socket.
WARNING! In the event of an anomaly, switch the appliance off and unplug from the socket. Do not dismantle or attempt to repair or modify the product. In the event of a malfunction, contact the service centre directly. WARNING! Do not expose the air conditioner to direct sunlight, as the colour of the materials may change; moreover, the appliance may overheat causing the protection mechanism to intervene and switch the appliance off.
DESCRIPTION OF THE APPLIANCE FRONT VIEW 1) CONTROL PANEL AND BUTTONS FOR OPERATION WITHOUT REMOTE CONTROL 2) FIN AND AIR FLOW OUTLET 3) FRONT 4) HANDLES 5) AIR INTAKE 6) HANDLES 7) DRAINAGE HOLE (DEHUMIDIFICATION) 8) AIR INTAKE 9) POWER PLUG SOCKET 10) POWER CORD OUTLET 11) DRAINAGE HOLE (COOLING) REAR VIEW 12) UPPER FILTER (BEHIND GRILLE) 13) UPPER AIR INTAKE 14) LOWER FILTER (BEHIND GRILLE) 15) LOWER AIR INTAKE 16) POWER CORD BUCKLE 17) CASTERS 18) REMOTE CONTROL (18) Min/max operati
APPLIANCE START-UP Open the packaging and pull out the box. Remove the product and the other elements supplied (illustrated in the box below). Infrared remote control. + button battery (CR2032/3V) Round fitting (1) for positioning between the air discharge outlet and the flexible pipe. Window unit kit with plug. Flexible pipe. Round fitting for window unit, for positioning between the end of the tube and the window unit itself. End fitting for window (2). Drainage tube (continuous drainage).
fitting for the window (2). The drainage tube can be compressed to minimum 45 mm and extended to maximum 1500 mm. It is advisable to keep the tube compressed to the minimum. with the handle. Place the end fitting against the fixed leaf of the window and draw the other leaf against it. 5. Avoid tight bends and folds in the flexible pipe. USE WITH WINDOW UNIT KIT 1. Make a hole having a diameter of roughly 133 mm on the glass window. 3.
HOW TO USE THE APPLIANCE This appliance can be used for PEARL cooling, heating (only model PEARL TOP), dehumidification and ventilation. When switching between modes, the fan continues to turn but the compressor stops: the compressor will re-start after 3 minutes. This delay protects the compressor from potential damage.
When the appliance is used as a dehumidifier, the flexible pipe must not be connected. For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly into the environment. The dehumidification mode is recommended during autumn and winter. If used during summer, it is best to leave the flexible pipe attached so that the hot air is discharged towards the outside rather than into the room.
REMOTE CONTROL OPERATION 1. Slide to open the cover according to the direction indicated by the arrowhead. 2. Insert the batteries (CR2032/3V) into the remote control and make sure the poles match. 3. Put back the cover. 4. Aim the remote control towards the receiver on the airconditioner. 5. The remote control should be within 8 meters away from the receiver. 6. No obstacles between the remote control and the receiver. 7. Do not drop or throw the remote control. 8.
FOR OPTIMAL REMOTE CONTROL OPERATION, POINT THE TRANSMITTER HEAD TOWARDS THE RECEIVER ON THE AIR CONDITIONER. 2 3 SPEED 4 SWING TIMER ON/ OFF 1 SLEEP + DRY COOLFAN 10 9 - 5 6 7 HEAT 8 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. ON/OFF BUTTON SPEED BUTTON SWING BUTTON TIMER BUTTON (LCD ON/OFF) SLEEP BUTTON “+” AND “-“ BUTTON FAN BUTTON HEAT BUTTON COOL BUTTON DRY BUTTON (1) “ON/OFF” BUTTON Press the ON/OFF button to turn on or off the air conditioner.
(6) “+” and “-“ BUTTON Press “+” or “-“ to regulate the temperature (the unit is 1°C) and set the time (the unit is 1h). The temperature ranges from 16°C to 32°C, and the time ranges from 1h to 24h. (7) “FAN” BUTTON Press “FAN” to start the Ventilation mode. (8) “HEAT” BUTTON Press “HEAT” to start the heating mode. (9) “COOL” BUTTON Press “COOL” to start the refrigeration mode. (10) “DRY” BUTTON Press “DRY” to start the dehumidification mode.
2. Cleaning the casing. Use a damp and soft cloth to clean the outer surface of the appliance. Do not use excessively hot water, solvents, petrol or other aggressive chemical compounds, talcum powder or brushes: these may damage the surface or colour of the casing. Remove any stains using lukewarm water with a little neutral detergent. Do not pour water onto the air conditioner to clean it, as this may damage its internal components or cause a short-circuit. 3. Storage.
