EN CERAMIC TOWER FAN HEATER for BATHROOM USE – IP21 OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Store these instructions in a safe place for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. Make sure that the type of mains power complies with the electrical requirements of the fan heater (220-240V~ /50Hz).
Keep flammable materials, such as furniture, cushions, blankets, paper, cloths, curtains and suchlike at least 1 m away from the front, sides and back. Disconnect the mains power when the appliance is not in use or during cleaning. Avoid using the fan heater in dusty environments or in the presence of flammable vapours (e.g. in workshops or garages). Do not place anything on the product; avoid placing wet garments on the fan heater. Use the heater in a well-ventilated area.
WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING. The symbol below signals the above warning: The fan heater may cause the risk of fire if, while in operation, is covered by or comes into contact with inflammable material including curtains, drapery, blankets, etc. KEEP THE FAN HEATER AWAY FROM THESE MATERIALS. Do not connect the fan heater to the power supply until it has been correctly assembled or positioned. Do not run the cord under carpets.
A fan heater contains parts that generate electrical arcs and sparks. It must not be used in potentially dangerous areas such as areas at risk of fire or explosion, or areas loaded with chemical substances or humidity. Do not use the appliance on soft surfaces such as beds, where the grilles may become covered. Always stand the fan heater on a flat, stable surface when in operation to prevent it from overturning. Arrange the cord so that the fan heater and other objects do not rest on it.
HOW TO USE THE FAN HEATER Set up the fan heater in a vertical position on a level and stable surface. Connect the power cord to a suitable electric socket (220-240V~/50Hz). Use the handle to move it. On/off button (on the back, underneath the air intake grille). Put the on/off button in the “I” position. When the appliance sounds a beep, this means that the fan heater is ready for use. Put the button in the “0” position to switch off the fan heater.
REMOTE CONTROL ON/OFF button SWING button – automatic swing Temperature and timer buttons High/low power button Temperature/timer button ECO SMART mode button Use Lithium/Manganese button cells, model no. CR2032 -3 V, compliant with Battery Directive no. 2006/66/EC (supplied with the remote control). HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below) Open the battery cover at the back of the remote control (press the back and pull the flap).
INFORMATION ON THE CORRECT DISPOSAL OF THE PRODUCT, PURSUANT TO DIRECTIVE 2012/19/EU ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT At the end of its useful life, this appliance must not be disposed of together with household waste. We call your attention to the crucial role played by the consumer in the reuse, recycling and other forms of recovery of such waste.
