EN METAL CERAMIC FAN HEATER OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the fan heater data plate (220-240V ~/50Hz).
automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned. Do not restrict the air inlet and outlet grilles. The appliance heats up slightly when in use. In order to avoid burns, do not let bare skin touch hot surfaces. Ensure that all objects are at least 1 meter from the front and sides of the appliance. Disconnect the mains power when the appliance is not used or for cleaning operations.
soapy water. Always remove the plug from the mains socket before cleaning. To disconnect the fan heater, push the switch to OFF and remove the plug from the socket. Pull on the plug only. Avoid pulling on the cord when disconnecting the fan heater. Do not place any objects on the cord and do not bend it. It is not advisable to use extension cords, as these may overheat and cause the risk of fire. Do not use a single extension cord to operate multiple appliances.
Upon initial start-up, the fan heater may emit a slight, harmless smell. This smell is a normal effect of the initial heating up of the internal heating elements, and should not recur later on. WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER. WHEN SERVICING OR MOVING THE FAN HEATER, ALWAYS UNPLUG THE POWER CORD. A fan heater has hot and arcing or sparkling parts inside.
DESCRIPTION OF PARTS 1. Control panel 2. Liquid crystal display 3. Air delivery grille 4. Base 5. Intake grille 6. On/off button HOW TO USE THE FAN HEATER Position the unit on a flat, stable surface. Connect the power cord to a suitable electric socket (220-240V~/50Hz). On/off button (on the rear, below the intake grille) Bring the on/off button to the “I” position. When the appliance emits a beep this means that the fan heater is ready for use.
ECO/COMFORT selection button ON/OFF buttons Touching the ON/OFF button will cause the - ECO mode: 1400 W reduced power to save energy - COMFORT mode: maximum heating power (2400W) ECO is the default mode. LED to light and the appliance will begin to Buttons Allows you to adjust the temperature and timer settings of the appliance. operate in COMFORT mode. Touching the button ON/OFF once again the mode selection LED will switch off.
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below) Open the battery cover at the rear of the remote control (press and pull the cover). Place the battery into the cover, observing the correct polarity. Insert the cover onto the remote control.
