Operation Manual

V 03/17

DESCRIPTION OF PARTS

ASSEMBLY INSTRUCTIONS

1. After removing everything from the carton, locate the motor unit and separate the front guard and back guard if they are

connected.

2. Locate the rear guard and align with the motor unit; the safety grille will only fit one way: with the handle facing up.

Insert 4 locking screws and tighten to secure the rear guard to the motor unit.

3. Screw on plastic nut tightly to attach the guard.

4. Loosen the set screw on the blade, slide the blade onto the shaft of the motor, tighten the set screw onto the flat of the

shaft to secure the blade.

5. Assemble the front guard to the rear guard. Tighten the connecting screw and nut, secure the retaining clips.

6. Remove the set screw on the pole , offer up and align the base with the hole on the pole insert the base set screw and

tighten.

BASE AND TUBE INSTRUCTIONS

The appliance does not need to be installed.

Fix the tube on the base plate by the joint screws.

Position the unit on a table.

HOW TO USE THE APPLIANCE

Connect the power cord to a suitable power socket (220-240 V~).

This fan can be used both as 3 fan speed options: low, medium and high.

This fan has a swivel action head giving a smooth oscillation action along with low noise levels, low electrical usage,

reliability with safety, while still providing efficient air flow.

The ON/OFF switch is incorporated in the rotary switch in the motor housing, where it’s possible to select the fan speed:

0- The Fan is switched Off

1- The Fan operates at the lowest speed

2- The Fan operates at the medium speed

3- The Fan operates at the highest speed

The fan can operate in oscillation or static mode. To make the fan head oscillate, push down the Oscillation Knob.

To stop the fan head from oscillating, pull-up the Oscillation Knob.

A Thermal protector device was mounted in the motor. When overheats due to various reasons, the temperature of the

motor reaches the fusing point, it will cut off automatically, make the fan safe efficiently. When the protector is fused, the

fan should be eliminated trouble and replace a new thermal protector before the fan is used again.

1. Oscillation knob

2. Switch knob

3. Motor

4. Power cord

5. Adjusting knob

6. Base set screw

7. Base

8. Rear guard

9. Set screw

10. Blade

11. Nut

12. Screw

13. Front guard