Install Instructions

P/N 240005165, Rev A [06\08]
An ISO 9001-2000 Certified Company
ARGOIRSERIESCONTROL
IR882
ARGO (Technical Support)
2201 Dwyer Avenue
Utica, NY 13501
(Corporate Sales)
85 Middle Road
Dunkirk, NY 14048
www.argocontrols.com
INSTALLATI
ONMANUALANDO
PERATINGINSTRUCTIONS
INSTALLATION MANUAL
AND OPERATING INSTRUCTIONS
P/N#240005165, Rev. 1.1 [08/06]
! !
RETAIN THIS MANUAL FOR FUTURE
REFERENCE
SAFETY SYMBOLS
The following defined symbols are used
throughout this manual to notify the reader
of potential hazards of varying risk levels.
DANGER
Indicates an imminently hazard-
ous situation which, if not avoid-
ed, WILL result in death or serious
injury.
! !
! !
CAUTION
Indicates a potential hazardous situa-
tion which, if not avoided, MAY result
in minor or moderate injury. It may
also be used to alert against unsafe
practices.
IMPORTANT: Read the following
instructions COMPLETELY before
installing!!
WARNING
Indicates a potentially hazardous
situation which, if not avoided,
COULD result in death or serious
injury.
MOUNTING INSTRUCTIONS
Mount the control horizontally on a solid wall
or part tion For your convenience t s rec
ommended that the control be mounted as
close as possible to the dev ce to be con
trolled The control should never be mount
ed more than 75 feet away Select a location
that is easily accessible for installation and
serv ce
NOTE: To reduce the possibility of re
lay noise that is sometimes amplified by
mounting surfaces such as sheet met
al plasterboard, and similar materials,
place rubber or felt washers between
the case and the mounting surface
1. Slide the Argo R882 Series Control
Board out of the mounting rail
2 Position the mounting rail and mount t
using at least 2 screws (not provided)
3. Slide the R882 Control Board back
into the mounting rail.
! !
ELECTRICAL SPECIFICATIONS
& WIRING
WARNING
ELECTRICAL SHOCK HAZARD!
Disconnect power before install
ing or servicing. Can cause severe
personal injury, death, or substan-
tial property damage if ignored.
INTRODUCTION
This manual is intended to familiarize
the installer and user of the Argo IR882
Control Board with its installation and
operation, to assure normal trouble-
free performance of the control.
Argo controls are designed and manu-
factured with quality components to
require minimal service and for maxi-
mum life and durability. Read these
instructions before installing and oper-
ating the control. It is imperative that
the instructions be followed carefully to
insure a satisfactory installation. Fail-
ure to do so may result in breach of
warranty.
! !
WARNING
All installations should be
done only by a qualified expert
and in accordance with the ap-
propriate Argo manual. Install-
ing an electric appliance with
improper methods or materials
may result in serious injury or
death due to fire.
P/N 240005165, Rev. A (6/08)