Operation Manual

V 10/16

OPERATING INSTRUCTIONS

FILLING THE WATER TANK

1. Firstly, remove the mist discharge nozzle from the water tank, by

simply turning the appliance upside-down.

2. Remove the water tank from the appliance, by simply pulling the

handle upwards.

Remove the plug on the bottom of the tank by unscrewing it anti-

clockwise.

WARNING: when moving the appliance, do not grip the

tank handle but hold the appliance from the bottom.

3. Fill the water tank exclusively with tap water, without adding any

aromatic fragrances or essences.

 Do not fill the tank with liquids other than tap water. Liquids with different

composition may damage the humidifier’s internal components and cause

malfunctions.

 Do not add essences, perfumes, detergents, chemical agents, hot water

(above 40°C) etc. to the water in the tank as these may damage the

humidifier’s water tank or several internal components and cause

malfunctions.

 Do not add water directly inside the bottom section of the appliance beneath

the tank, or in the discharge nozzle. The water that may penetrate inside the

bottom section of the appliance may cause malfunctions.

 Do not knock or throw the water tank as it may break or cause water

leakages. Do not use the water tank if it has suffered heavy knocks. Contact

the technical assistance service as soon as possible.

 Fill the humidifier with clean water daily and keep it clean.

4. Close the water tank plug correctly.

Ensure that the rubber ring has been placed on the tank plug then

tightly secure the latter by turning it anti-clockwise, to prevent air from

entering the tank and causing possible malfunctions.

5. Replace the water tank and mist discharge nozzle.

Properly replace the water tank and mist discharge nozzle inside the

tank before starting the appliance, or the discharged mist will wet the

humidifier and surrounding environment.

Do not move the humidifier after putting the tank back in place, as this

may cause water leakages and possible malfunctions.