Operation Manual

ManualsBrandsArgo ManualsAir ConditioningHydro Digit

V 10/16

TROUBLESHOOTING

 In the event of malfunctions, check the following points before contacting the technical assistance centre.

 Should you not be able to solve the problem, please contact the technical assistance centre nearest to

you.

Problem

Possible cause Suggested solution

The plug is not properly inserted into

the socket.

Insert the plug properly into the socket.

The appliance does not emit mist.

The “WATER” indicator light on the

display turns on/off (the water tank is

empty).

Add water in the tank.

The appliance is operating in the

“LOW” mode (the display visualises

“LOW”).

It is not a fault. To increase the amount

of mist, select the “HIGH” mode by

pressing the “MIST CAPACITY” button.

The appliance emits very little

steam.

There are some deposits on the

nebuliser’s surface.

Clean the nebuliser.

The air intake slots are dusty.

Clean the air inlet slots. Humidity levels

may vary in different points even of the

same room.

The difference between the ambient

humidity and the humidity detected

by the internal sensor is too high.

The humidifier is positioned in a spot

highly exposed to the outside

environment, for example near a

window.

Place the humidifier in a spot that is not

exposed to the outside environment.

The water in the tank is not fresh.

A strange smell is emitted with the

mist.

Deposits or dirt have built up inside

the water tank or nebuliser.

Clean the humidifier according to the

instructions and replace the water in the

tank with fresh water.

A "pu…..” sound is heard.

It is the sound of water flowing from

the tank to the slot.

A "po…..” sound is heard.

It is the noise of the fan.

It is not a fault, continue using the

appliance normally.