EN ULTRASONIC HUMIDIFIER OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damages. Store these instructions.
GENERAL OPERATING AND SAFETY INSTRUCTIONS The appliance is a highly effective humidifier: use this humidifier only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or malfunctions. Ensure that the mains voltage complies with that indicated on the data plate (220-240VAC/50Hz).
cord is damaged, it must be replaced by the service centre, so as to avoid any safety risks. Do not use the appliance in the presence of other electric equipment such as computers or precision instruments. The humidity or “white dust” contained in the mist may cause the appliances to malfunction. In the event of an anomaly, switch the appliance off and remove the plug immediately. Do not dismantle, repair or modify this product freely.
Do not place the appliance on blankets or carpets as these may block the entry of air underneath the appliance and cause faults or malfunctions. Do not place the appliance on or close to furniture or curtains. The mist may wet the furniture or curtains causing them to fade or deform. Moreover, the “white dust” included in the mist may alter the surfaces of furniture: therefore, the mist jet should not be directed towards furniture.
WARNING: THE ON/OFF SWITCH IS NOT THE ONLY MEANS TO DISCONNECT THE POWER SUPPLY. ALWAYS PULL OUT THE PLUG FROM THE SOCKET IN THE EVENT OF MAINTENANCE OPERATIONS, WHEN MOVING THE APPLIANCE OR WHEN THE LATTER IS NOT USED.
DESCRIPTION OF THE APPLIANCE CONTROLS Humidity level adjustment WARNING: when moving the appliance, do not grip the tank handle (1) but hold the appliance from the bottom.
OPERATING INSTRUCTIONS FILLING THE WATER TANK 1. Firstly, remove the mist discharge nozzle from the water tank, by simply turning the appliance upside-down. 2. Remove the water tank from the appliance, by simply pulling the handle upwards. Remove the plug on the bottom of the tank by unscrewing it anticlockwise. WARNING: when moving the appliance, do not grip the tank handle but hold the appliance from the bottom. 3.
OPERATING INSTRUCTIONS HOW TO ACTIVATE THE HUMIDIFIER 1. Insert the power supply plug in the socket: the humidifier will emit a buzzer sound. WARNING! Use alternating current (AC) as specified on the data plate. Higher voltages may cause the risk of malfunctions, fire or electric shock. WARNING! Do not use the humidifier if the cord or plug are damaged, or if the plug does not fit tightly into the socket. This may cause sparks, short-circuits or electric shocks.
OPERATING INSTRUCTIONS OPERATION IN THE “AUTO” MODE The AUTO mode automatically activates after pressing the ON/OFF button when turning on the humidifier, without selecting any function.
OPERATING INSTRUCTIONS CUSTOM SETTING MODE Press the “ON/OFF” button to start the appliance. Press the “Set up” button repeatedly to set the desired operating mode. Once the desired mode has been set, the mist emission level can be freely adjusted (to high, medium or low), the % of humidity and the timer. MIST EMISSION ADJUSTMENT By pressing the "MIST CAPACITY" button each time, the amount of mist emitted can be adjusted (low=L; medium=M; high=H). The display will indicate the set level.
OPERATING INSTRUCTIONS HOW TO TURN OFF THE HUMIDIFIER 1. Press the ON/OFF button, the indicator lights on the display start fading. Press the ON/OFF button again, a buzzer sounds and the humidifier turns off. 2. Remove the plug from the socket. MIST EMISSION WITH A FULL TANK WITH THE WATER TANK FULL When the humidifier operates in: - “Low” mode: it may humidify continuously for roughly 60 hours. - “Medium” mode: it may humidify continuously for roughly 30 hours.
PARTS TO BE REPLACED ION EXCHANGE FILTER A removable ion exchange filter is housed inside the humidifier: its function is to remove the calcium and magnesium salts normally contained in water, as these may turn into “white dust” if they vaporise and deposit on furniture, objects and floors. For this reason, it is important to replace this filter regularly. The ion exchange filter may cause the water to assume a tea-like colour in the initial stages of operation.
CLEANING AND MAINTENANCE PRECAUTIONS Warning Always remove the plug from the socket before cleaning the appliance, or electric shocks and malfunctions may occur. MAINTENANCE OF THE HUMIDIFIER’S EXTERIOR SURFACE Use a damp and soft cloth to clean the humidifier’s exterior surface. Warning Do Do not wet the appliance or immerse it in water to avoid electric shocks. not use solvents, petrol, xylene, talcum powder and brushes: these products may damage the surface or alter the casing colour.
CLEANING AND MAINTENANCE MAINTENANCE OF THE WATER TANK AND DISCHARGE NOZZLE 1. Remove the discharge nozzle and unscrew the plug on the bottom of the tank by turning it anti-clockwise to eliminate the residual water. The discharge nozzle will fall if it is not removed before eliminating the water. 2. Clean the water tank and relative plug using clean water. Clean the water tank plug carefully, without applying force, so as to avoid water leakages from the plug itself. 3.
TROUBLESHOOTING In the event of malfunctions, check the following points before contacting the technical assistance centre. Should you not be able to solve the problem, please contact the technical assistance centre nearest to you. Problem Possible cause Suggested solution The plug is not properly inserted into the socket. Insert the plug properly into the socket. The “WATER” indicator light on the display turns on/off (the water tank is empty). Add water in the tank.
