EN DESK AND STAND FAN OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference. .
GENERAL SAFETY INFORMATION Use this fan only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. Ensure that the mains power complies with the voltage specified on the fan ’s data plate (220-240V~/50Hz). This product is not a toy. Children should be adequately supervised to ensure that they do not play with the appliance.
DESK FAN - DESCRIPTION OF PARTS AND ASSEMBLY INSTRUCTIONS 1. Front grille 2. Nut 3. Ring 4. Blade 5. Nut 6. Rear grille 7. Motor shaft 8. Motor housing 9. Neck 10. Control box and body 11. Base 12. Screws 13. Remote control 13 Open the box and remove the parts of the appliance. Connect the base (11) to the body of the appliance (10) using the screws supplied (12). Insert the rear grill (6) on the motor shaft (7) in the proper position (hanlde upward).
Set the height of stand fan by means of height adjustment ring (13). Insert the rear grill (6) on the motor shaft (7) in the proper position (hanlde upward). Screw the nut (5) in order to fasten the rear grill firmly. Set the blade (4) on the motor shaft (7). Tighten the nut (2) on the motor shaft (caution - counterclockwise direction). With the aid of the ring (3) join front and rear grill and tighten the screw on the ring. The appliance does not need to be installed.
REMOTE CONTROL 2. MODE SELECTION button (MODE) Allows you to adjust 3 modes (SLEEP, NATURAL, NORMAL). The LEDS SLEEP, NATURAL, NORMAL, will switch on simoultaneously. 1. TIMER button When the appliance is operating, the operating time can be set by touching the TIMER button: from 0,5 to 7,5 hours, with each touch corresponding to half an hour. The TIMER DISPLAY is switched on simultaneously and shows the time set. The unit will switch off automatically at the end of the programmed time. 3.
MAINTENANCE AND STORAGE ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE. IMPORTANT: DO NOT SUBMERGE THE FAN IN WATER. Cleaning the outside surface of the appliance Turn the switch off and unplug before carrying out any maintenance work or moving the appliance. Use a soft cloth to remove any dust from the fan. If the fan is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower than 50°C. Let the fan dry completely before use.
