EN DEHUMIDIFIER OPERATING INSTRUCTIONS Read the instructions carefully before operating or servicing the dehumidifier. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference.
GENERAL OPERATING AND SAFETY INSTRUCTIONS This appliance is a highly efficient dehumidifier, designed for domestic use only! Use this dehumidifier only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or malfunctions. The unit contains refrigerant; keep it vertical at all times. Once you have opened the unit, keep it vertical to allow the refrigerant to stabilise and wait two hours before operating it.
Do not bend, drag or twist the cord, or apply force to remove it. Do not operate the unit if its cable or plug are damaged; doing so can cause fires or electric shock. If the power cord is damaged, it must be replaced by a service centre. Do not place heavy objects on top of the appliance. To prevent water spills, empty the water tank before moving the appliance. Do not tilt the dehumidifier onto one side or turn it upside down, as the water which runs out could damage the appliance.
Do not move the appliance while it is operating; doing so can cause leaks and malfunction.
WARNING: After each interruption of its operation, at least 3 minutes must pass before the dehumidifier starts up again: this delay prevents the compressor being damaged. If, on the other hand, the set humidity percentage is higher than the level currently found in the room, the dehumidifier will not start.
DRY BABY 11 CONTROL PANEL DEFROST LED TANK FULL LED STAND BY LED HUMIDITY ADJUSTER KNOB HUMIDITY ADJUSTER KNOB: sets the desired humidity %. Turn the knob fully counterclockwise (seen from in front of the appliance), to turn the appliance OFF. Turn the knob clockwise (seen from in front of the appliance) to set the humidity % (decreasing)(80-35%). TANK FULL LED: when the tank is full, the TANK FULL LED comes on and the appliance stops running. A 10 second beep sounds.
3. RELATIVE HUMIDITY ADJUSTER BUTTON: the humidity can be set from 35% to 80% in 5% steps with the + and buttons, or you can set the appliance to continuous drain (CO) – maximum dehumidification. 4. DISPLAY: shows the relative humidity setting. 5. FAN SPEED BUTTON: press this button to set the fan speed (LOW / HIGH). 6. TIMER ON/OFF BUTTON: delayed on/off button (2 or 4 hour delay). TIMER LED: shows the timer setting (2 or 4 hours). HIGH/LOW FAN SPEED LED: shows the fan speed: HIGH or LOW.
CLEANING THE AIR FILTER The filter is designed to remove dust or dirt from the air. If the filter is clogged by dust, electricity consumption will be higher than normal. For most effective dehumidification, clean the filter every 250 hours of operation. After 250 hours of operation, the FILTER RESET (Dry Digit 13 and 17) led turns on to indicate that it is time to clean the filter. Cleaning instructions: 1. Compress the two tabs and pull the filter out. 2.
