EN CERAMIC FAN HEATER for BATHROOM USE – IP21 OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Store these instructions in a safe place for future reference.
GENERAL SAFETY INFORMATION Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. Make sure that the type of mains power complies with the electrical requirements of the fan heater (220-240 V~/50 Hz).
Keep flammable materials, such as furniture, cushions, blankets, paper, cloths, curtains and similar items at least 1 m away from the front, sides and back of the appliance. Disconnect the mains power when the appliance is not in use or during cleaning. Avoid using the fan heater in dusty environments or in the presence of flammable vapours (e.g. in workshops or garages). Do not place anything on the product; avoid placing wet garments on the fan heater.
WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING. The symbol below signals this warning: The fan heater may cause the risk of fire if, while operating, it is covered or comes into contact with flammable material including curtains, drapery, blankets, etc. KEEP THE FAN HEATER AWAY FROM THESE MATERIALS. Do not connect the fan heater to the power supply until it has been correctly assembled or positioned. Do not run the cord under carpets.
A fan heater contains parts that generate electrical arcs and sparks. It must not be used in potentially dangerous areas such as those subject to the risk of fire or explosion, or areas filled with chemical substances or humidity. Do not use the appliance on soft surfaces such as beds, where the grilles may get covered. Always rest the fan heater on a flat and stable surface when it is running, so as to prevent it from toppling over.
CONTROL PANEL 3. OPERATING MODE BUTTON COMFORT – maximum heat (2000 W) ECO – minimum heat (1300 W) ventilation only (repetition sequence) 4. TIMER BUTTON: with the unit operating it allows for programming the switch-off after 1, 2 or 4 hours, by pressing it once, twice or three times (repetition sequence) 2. SELECTION BUTTON operation without PRESENCE SENSOR (NORMAL) or with PRESENCE SENSOR (BODY-S) 1.
The appliance is equipped with an anti-tipping device which interrupts operation when the product is tilted. Do not position the appliance on its side or upside down. CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE OPERATIONS. IMPORTANT: DO NOT IMMERSE THE CERAMIC FAN HEATER IN WATER Cleaning the outside surface of the appliance Use a soft cloth to remove any dust from the fan heater.
