User Manual

Clutch System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CS-4
Check the condition of the belt in the table below and perform the necessary servicing
procedure.
Belt Condition Problem Servicing Procedure
Glazed Sides
Torn Underchords
Worn Prematurely
Clutch Malfunction
Lubricant Contamination
Wrong Drive Belt
Old Drive Belt
Driver or Driven Clutch
Problem
Replacing the Drive Belt
Driver Clutch Servicing
Driven Clutch Servicing
Replacing the Drive Belt
Driver Clutch Servicing
Driven Clutch Servicing
Replacing the Drive Belt
Invance Driven Clutch
Replace the belt when:
◘ the top width of the belt has worn to 1-1/16" (27mm)
◘ cracks, fraying or shredding is apparent
◘ it becomes contaminated with oil or some other uid
Refer to the ARGO Parts Manual for correct drive belt part number.
Remove the Drive Belt (Invance)
1. Make sure the ignition is turned off.
2. Remove the engine access cover
3. Perform the servicing procedure, Removing the Firewall, in section VB
4. Place the transmission in neutral
The Invance Driven Clutch (transmission
clutch), is manufactured with a 6mm x 1.0
threaded hole in the clutch face. This hole
is provided to assist in spreading the driven
clutch pulleys apart by threading a 6mm x
1.0 thread bolt in through the face. This bolt
should be a least 2” in length with full thread.
Spreading the pulleys allows for easy removal
and installation of the 127-137 (Avenger) or
127-159 (Frontier) drive belt. Photo 1
Photo 1