EN ELECTRIC CONVECTOR HEATER WITH GLASS PANEL IP24 OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION Use this convector only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. This convector is designed for domestic use. It must not be used for commercial or industrial purposes. Ensure that the mains voltage complies with that indicated on the convector data plate (220-240VAC/50Hz).
covered or incorrectly positioned. The appliance is equipped with an IP24 degree of protection and can be used in private bathrooms in zone 2. The convector must not be touched by people that use bath tubs and showers. Disconnect the mains power when the appliance is not used or for cleaning operations. To disconnect the convector, set the selector to 0 and remove the plug from the socket. Pull on the plug only. Do not pull the cord.
in water or other liquids. Do not touch the plug or convector with wet hands. Avoid using the convector in dusty environments or in the presence of flammable vapours (e.g. in workshops or garages). Do not place the convector above or near another heat source. WARNING: AVOID COVERING THE CONVECTOR TO PREVENT IT FROM OVERHEATING.
convector when it is hot or in operation, in order to avoid the high temperatures ruining the cord. Do not operate the convector outdoors. Do not use the convector in front of or near an open window. WARNING: do not use the convector with an external controller or any other external device that activates the convector automatically, as there may be a risk of fire if the convector is covered or incorrectly positioned. Upon initial start-up, the convector may emit a slight, harmless smell.
DESCRIPTION OF PARTS FRONT VIEW SIDE VIEW A REAR VIEW E D B C A. Delivery/intake grille B. Feet with wheels C. ON/OFF switch F D. Side Control panel E. Rear holes for wall mounting F. Rear brackets for wall mounting HOW TO INSTALL THE APPLIANCE The convector can be used on the floor, after assembling the feet, or alternatively it can be wall-mounted using the specific accessories supplied. MONTARE I PIEDINI IN DOTAZIONE A.
1. Unscrew the two screws on top of the 2 vertical bars of the wall bracket. 2. Pull down the wall bracket by pressing downward on the top of the two vertical bars of the wall bracket. 3. Remove the bracket for wall mounting from the convector completely. 4. By supporting the bracket onto the wall, mark on the wall with a pencil the points where it is necessary to make the holes in order to insert the Fishers. Observe the minimum distances from the walls as pointed out in the picture below. 6.
. Tighten the screws at the top of the convector firmly. 9. Installation complete. HOW TO USE THE CONVECTOR Connect the power cord to a suitable electric socket (220-240V~/50Hz). ON/OFF switch (on the right side) Bring the on/off switch to the “ON” position. When the appliance emits a beep this means that the convector is ready for use. Bring the switch to the “0FF” position to switch off the convector.
CONTROL PANEL TIMER button TEMPERATURE button When the appliance is operating, the operating time can be set by touching this button: the timer display shows a flashing 0 and pressing TIMER you can set the desired time, between 0,5 and 8 hours, with each touch corresponding to half and hour. The display shows the set time: wait 5” for the setting to be confirmed. The unit will switch off automatically at the end of the programmed time (stand by). In order to switch it on again press the button ON/OFF.
Information for correct disposal of the battery in accordance with the European Directive 2006/66/EC Please replace battery when its electricity charge is used up: please do not eliminate this battery together with normal household waste. It must be taken to special local community waste collection centres or to a dealer providing this service.
