Datasheet

13
V 05/13
4. By supporting the bracket onto the wall, mark on the
wall with a pencil the points where it is necessary to
make the holes in order to insert the Fishers. Observe
the minimum distances from the walls as pointed out
in the picture below.
5. Drill holes in the wall and insert the 4 Fishers.
Secure the bracket to the wall and insert the 4
screws supplied.
6. Place the unit upright. Insert the two lower parts of the
bracket into the holes on the rear of the convector in the
lower part.
7. Insert the two upper parts of the bracket into the
holes on the rear of the convector in the upper
part.
8. Tighten the screws at the top of the convector firmly.
9. Installation complete.