Datasheet

12
V 05/13
HOW TO INSTALL THE APPLIANCE
The convector can be used on the floor, after assembling the feet, or alternatively it can be wall-mounted using the
specific accessories supplied.
MONTARE I PIEDINI IN DOTAZIONE
A. Floor portable using: how to assemble the feet with wheels supplied
The convector is packed without feet. These must therefore be assembled before using the appliance.
Assemble the feet as shown in the figure and put the convector in an upright position. Position the unit on a flat,
stable surface and stop the wheels with the proper wheels locks before turning it on.
1. Turn the convector upside down and
loosen the wing nuts.
2. Insert the feet. The longest part
must be positioned behind on
the rear the convector.
3. Tighten the wing nuts on the feet.
B. Wall-mounting: how to assemble the rear bracket and mount the convector onto the wall
The convector packaging contains all the accessories necessary for wall-mounting.
To wall-mount, proceed as follows:
Remove the rear bracket from the back of the unit as described in the pictures below.
1. Unscrew the two screws on top of the 2
vertical bars of the wall bracket.
2. Pull down the wall bracket by pressing downward on the
top of the two vertical bars of the wall bracket.
3. Remove the bracket for wall mounting from the convector completely.