EN ELECTRIC CONVECTOR HEATER WITH GLASS PANEL IP24 OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations. Observe all the safety instructions; failure to observe the instructions may cause accidents and/or damages. Store these instructions for future reference.
GENERAL SAFETY INFORMATION x Use this convector only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. x Ensure that the mains power complies with the voltage specified on the convector data plate (220-240V~/50Hz). x This product is not a toy. Children should be adequately supervised to ensure that they do not play with the appliance.
x Do not position the convector below a socket outlet. x Do not operate the appliance outdoors. WARNING: do not use the convector with a controller or any other external device that activates the appliance automatically, as there may be a risk of fire if the convector is covered or incorrectly positioned. x Upon initial start-up, the convector may emit a slight, harmless smell. This smell is a normal effect of the initial heating up of the internal heating elements, and should not recur later on.
HOW TO INSTALL THE APPLIANCE The convector can be used on the floor, after assembling the feet, or alternatively it can be wall-mounted using the specific accessories supplied. MONTARE I PIEDINI IN DOTAZIONE A. Floor portable using: how to assemble the feet with wheels supplied The convector is packed without feet. These must therefore be assembled before using the appliance. Assemble the feet as shown in the figure and put the convector in an upright position.
4. By supporting the bracket onto the wall, mark on the wall with a pencil the points where it is necessary to make the holes in order to insert the Fishers. Observe the minimum distances from the walls as pointed out in the picture below. 6. Place the unit upright. Insert the two lower parts of the bracket into the holes on the rear of the convector in the lower part. 8. V 05/13 Tighten the screws at the top of the convector firmly. 5. Drill holes in the wall and insert the 4 Fishers.
HOW TO USE THE CONVECTOR Connect the power cord to a suitable electric socket (220-240V~/50Hz). ON/OFF switch (on the right side) Bring the on/off switch to the “ON” position. When the appliance emits a beep this means that the convector is ready for use. Bring the switch to the “0FF” position to switch off the convector.
REMOTE CONTROL TIMER button TEMPERATURE button ON/OFF button Mode selection button ECO, SUPER or COMFORT The remote control uses Lithium/Manganese button cells, model no. CR2032 -3 V, compliant with Battery Directive no. 2006/66/CE (supplied with the remote control). HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below) Open the battery cover at the rear of the remote control (press and pull the cover). Place the battery into the cover, observing the correct polarity.
