Install Instructions
7
MOUNTING INSTRUCTIONS
Mount the Argo ARM Series Switching Relays vertically on a solid
wall or partition. For your convenience it is recommended that the
control be mounted as close as possible to the device to be con-
trolled. The switching relay should never be mounted more than 75
feet away. Select a location that is easily accessible for installation
and service.
NOTE: To reduce the possible transformer hum and relay noise
that is sometimes amplied by mounting surfaces such as
sheet metal, plasterboard, and similar materials, place rubber
or felt washers between the case and the mounting surface.
1. Position the control and mark the mounting holes.
2. Start screws (not provided) for the keyhole type mount-
ing holes in the upper corner(s). Tighten the screws down
to about ⅛” (3mm) from the surface. The AD-1 will require a
screw to be installed in the lower left hand corner after the
control is hung and leveled.
3. Hang the control on the screw(s), position the case, and
start the bottom screws.
4. Tighten all screws.