User Guide

MOUNTING INSTRUCTIONS

Mount the Argo ARH Series Control vertically on a solid wall or par-

tition. For your convenience it is recommended that the control be

mounted as close as possible to the device being controlled, how-

ever it should never be mounted more than 75 feet away. Select a

location that is easily accessible for installation and service.

NOTE: 

        





1. Position the control and mark the mounting holes.

2. Start screws (not provided) for the keyhole type mounting holes

in the upper corner(s). Tighten the screws down to about ⅛”

(3mm) from the surface. The ARH-1 will require a screw to be

installed in the lower left hand corner after the control is hung

and leveled.

3. Hang the control on the screws, position the case, and start the

bottom screws.

4. Tighten all screws.

ARH CONTROL BOARD DIAGRAMS

Continued

RELAY

ARH-3